Description
This is a complete kit of the hardware parts for the 9.5m EFHW described at https://zindello.com.au/?p=51
This kit comes with the 3D printed parts and the conduit sections required to make one of these antennas. These parts are:
UnUn Housing to suit up to two stacked FT82-43 or FT114-43 cores
UnUn Endcap with hole for RG-174 as counterpoise and capacitor, and hole for panel mount female BNC connector
UnUn Endcap with hole for Terminal Connector for the antenna
2x 16mm/20mm tube loading coil end caps (for top coil)
2x 40mm/20mm tube loading coil end caps (for bottom coil)
In order to complete one of these antennas, you will need to also supply/source locally:
Approx 20m of #22AWG Tefzel wire
Approx 1m of 0.8mm enamelled copper wire
1 (or 2 if stacking) FT82-43 or FT114-43 cores (depending on your power requirements)
1 Panel Mount BNC connector
1 Panel Mount Screw Terminal/Banana Connector
Reviews
There are no reviews yet.